![]() ::: completed emerge (1 of 1) sys-apps/baselayout-1.12.10-r5 to / ::: completed emerge (1 of 1) sys-apps/iproute2-2.0710 to / Posted: Wed 9:17 am Post subject: Snip from the emerge.log Is it possible to boot up some older kernel? What exactly did you upgrade which could conflict with ipsec? Racoon worked before the system upgrade, now it doesn't (but I guess you are onto something but I don't know why netstat doesn't show it). HOST1 is a NAT:ed server on a private network with a router that forwards IKE-port 500 to this host. ![]() HOST2 is a server on a public IP which is not firewalled (otherwise than iptables that is). If I'm pinging from another host to HOST2 I get a reply as expected. This even although the machine is rebooted and not iptables nor Racoon services are started on NEITHER HOST1 or HOST2 (I'm not getting a reply). Unix 2 STREAM LISTENING 8508 /var/run/proftpd/proftpd.sockĭoesn't seem to be anything here are there? (ports 33 are mysql network ports) Unix 2 STREAM LISTENING 8352 /var/run/cgisock Unix 2 STREAM LISTENING 8496 /var/run/proftpd/proftpd.sock Unix 2 STREAM LISTENING 8133 /var/run/mysqld/mysqld3.sock Unix 2 STREAM LISTENING 8114 /var/run/mysqld/mysqld2.sock Unix 2 STREAM LISTENING 8093 /var/run/mysqld/mysqld.sock Proto RefCnt Flags Type State I-Node Path Proto Recv-Q Send-Q Local Address Foreign Address StateĪctive UNIX domain sockets (only servers) Here's the result of netstat -l command Code:Īctive Internet connections (only servers) Posted: Tue 4:26 pm Post subject: Something. ![]() Is "HOST2" a local LAN adress or a public one? It looks like something is blocking port 500, so racoon can't bind to it.ĮRROR: failed to bind to address HOST2 (Cannot assign requested address).Ĭould you check if there are other services running which might block this port? (netstat -l) Last edited by Moreaulf on Wed 1:31 pm edited 1 time in total Path pre_shared_key "/etc/racoon/psk.txt" ĭoes anyone know why Racoon doesn't start since upgrade.? 13:16:57: DEBUG: open /var/lib/racoon/racoon.sock as racoon management. 13:16:57: DEBUG: compression algorithm can not be checked because sadb message doesn't support it. The "/etc/init.d/racoon start" command fails: Kernel upgrade was successfull and I have rebuild it with all (as far as I know) necessary modules for Ipsec.Īll IP:s are translated to HOST1 and HOST2 where HOST1 is the machine I'm working on first (HOST2 has the same setup and I'm trying to setup a working VPN connection between these) I've spent alot of time since the update trying to find out why but I can't seem to find any information relevant enough to work as a solution for me. I had some problems configuring VPN a couple of months ago but thanks to Rob1n and massimo I got a few necessary pushes in the right direction.Ī couple of days ago I updated the servers software and since then the Racoon service refuse to start. Posted: Tue 12:26 pm Post subject: Racoon error after update Gentoo Forums Forum Index Networking & Security Gentoo Forums :: View topic - Racoon error after update
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |